| Surface Preparation |
Concrete:
The surface should be dry, clean, free from loose particles, oil and other chemicals. The cleaned surface is wetted with a brush or sponge and made ready for concrete or repair application.
Steel Surface :
The surface must be clean and should be free of oil, rust, burrs, concrete residues and other chemicals. The surface is made suitable for application by sandblasting. In cases where it is not possible to work with sandblasting, cleaning is carried out with airbrush gun or wire brush. In cases where the surface is greasy and oily, oil remover should be used to clean it. The optimum cleaning grade is SA 2.
|
| Preparation Instructions |
Depending on the desired consistency, powder(25 kg) is poured into approximately 4.5 kg of clean cool water and a homogenous mixture is provided in 3-4 minutes with a low speed mixer without agglomeration and allowed to stand for ~ 5 minutes. Water should not be added to the powder material.
For Brush Application:
Water / Powder material ratio ~ 1 / 5.7 kg
For Spray Application;
Water / Powder material ratio ~ 1 / 5.4 kg
|
| Application |
As an Adherence Mortar:
The efflorescent material is mixed again and ready for use. It is applied by brushing or spraying it thoroughly on the surface. Shortly after application; When the LRC RM AC material on the surface is still wet, concrete or repair mortar application should be started.
Corrosion Preventing Primer:
The efflorescent material is mixed again and ready for use; all surfaces are covered with a soft paint brush on the prefabricated iron reinforcement. The second coat can be applied after the first coat has dried( after about 3-4 hours). Approximately 30 minutes after the application is finished, concrete surfaces and equipment can be covered with repair mortar.
|
| Things to pay attention |
• The prepared material should be used within about 1 hour, water and dust should not be added to the mix.
• The application area must be protected for first 24 hours, from direct sunlight, wind, rain and freezing.
• The application temperature is recommended to be +5 ° C to +30 ° C, – not to be applied at temperatures below 5 ° C.
|
| General considerations |
The above product information and explanations are based on our experience and the end result of our careful research. The diversity of the materials involved, the different construction and working conditions cannot be individually controlled or influenced by us. In non-control applications, the warranty status is limited only to the quality of the product sold. There is no guarantee for the application other than the production of the product. This technical paper invalidates the previous existing form. The quality of the work done may vary depending on your professional use of the product. If you are unsure, do a little test or get technical help.
|
| Disposal |
Empty packaging can be disposed of in collection boxes according to local-local regulations or recycling rules. After drying and hardening the used waste material, dispose of it as construction waste. It is dangerous to destroy product residues by burning.
|
| Safety Information |
Keep the products out of the reach of children. Keep the covers of the products closed. It is recommended to wear gloves and goggles during work. If the skin comes into contact with the material, it should be washed with soapy water immediately. In case of contact with eyes, seek medical advice immediately. For more detailed information, see the material safety data sheet.
|
