| Surface Preparation |
Surface Preparation:
Substrate must be cleaned of off loose particles oils and other chemicals. The repairs on the substrate must be done with an appropriate LRC Repair Mortar.
Primer:
For a sound application, LRC 2B liquid component can be diluted 1/10 ratio and applied on the surface via a hard brush. Wait until it dries before applying LRC 2B Consumption is approximately 200-250 gram/m².
On surfaces that have segregation and pores, the surface must be repaired before priming. Otherwise, the humidity that is trapped in the pores can generate bubbles.
|
| Preparation Instructions |
Liquid component of LRC 2B is mixed with a low revolution mixer prior to adding the powder component. The powder component is added into the liquid component and is mixed until a homogeneous mixture is obtained. The mixture is applied with a roller, brush, or a low-pressure sprayer.
|
| Application |
In a single layer 2-5 mm thickness can be applied. For multi-layer applications complete curing in between layers is necessary.
When higher compression strength requirements with the aid of LRC Textile Membrane, fiber glass, felting, netting excellent results can be obtained.
For applications with reinforcement initially one layer of LRC 2B is applied and the reinforcement is applied on wet product. The following layers are applied to attain the desired thickness.
Note: Each layer must cure before the second layer is applied.
|
| Corners, Cold Joints and Dilatation Insulation |
Outer, Inner and Flat Corners:
Wall-Flooring joints must be insulated 24 hours before the application. Application can be done with the aid of LRC EST Elastic Joint Sealing Tapes. (Ref. LRC EST TDS)
Dilatation and Cold Joint Insulation:
All dilatations and cold joints must be filled with an elastomeric grout filling. Dilatations must be insulated with a LRC EST Dilatation Accordance with regulation. (Ref. LRC EST Dilatation TDS)
|
| Things to Consider |
• LRC 2B has a great adherence after the water evaporates. However, if this product is used on the negative side this product will not perform just as well.
• In different environments, application methods the curing times may vary.
• Cannot apply on frozen and wet surfaces
• Fresh applications must be protected from frost, rain, dew, and water until it cures
|
| General considerations |
The above product information and explanations are based on our experience and the end result of our careful research. The diversity of the materials involved, the different construction and working conditions cannot be individually controlled or influenced by us. In non-control applications, the warranty status is limited only to the quality of the product sold. There is no guarantee for the application other than the production of the product. This technical paper invalidates the previous existing form. The quality of the work done may vary depending on your professional use of the product. If you are unsure, do a little test or get technical help.
|
| Disposal |
Empty packaging can be disposed of in collection boxes according to local-local regulations or recycling rules. After drying and hardening the used waste material, dispose of it as construction waste. It is dangerous to destroy product residues by burning.
|
| Safety Information |
Keep the products out of the reach of children. Keep the covers of the products closed. It is recommended to wear gloves and goggles during work. If the skin comes into contact with the material, it should be washed with soapy water immediately. In case of contact with eyes, seek medical advice immediately. For more detailed information, see the material safety data sheet.
|
