| Surface Preparation |
You should wait enough for the adherence of ceramics and tiles. Before the application of grouting, the surface should be cleaned by means of comb or an appropriate grouting stick and should be moisten by means of wet sponge.
|
| Preparation Instructions |
Appropriate water amount (6,2lt water for 20 kg sack) is poured into clean mixing pot. By shedding powder material on it, the mixture is properly stirred until there is no lump in it. After it is rested for 2-3 minutes, it is stirred again. LRC™ JF is laid on ceramics by means of rubber trowel, and the joint intervals are filled. Surplus material is diagonally taken from the joints. For the deep joints, first of all it should be waited for the material to be absorbed and this process should be done again. İt is waited for the material to be resistant against finger pressure. Whole surface is glazed with a wet sponge and watered. This process is made in order to balance the hydration, and the surplus materials are cleaned and LRC™ JF is given their final shapes. The following day, ceramics are polished by means of dry and clean cloth after the material is dried.
|
| Things to pay attention |
• LRC™ JF shouldn’t be used under +5°C temperatures and under rainy and windy weathers.
• Water or powder mortar shouldn’t be added to LRC™ JF which started to dry.
• 15-20 minutes after the material is applied, finger pressure test should be carried out. If the material resist to finger pressure and the fingers are not contaminated by the materials in the finger test,
• LRC™ JF should be watered and then the ceramics are polished by means of dry and clean cloth and LRC™ JF should be shaped by being moisten. As a result, LRC™ JF is ensured to be dust and crack fee and the excellent surface smoothness is ensured.
|
| General considerations |
The above product information and explanations are based on our experience and the end result of our careful research. The diversity of the materials involved, the different construction and working conditions cannot be individually controlled or influenced by us. In non-control applications, the warranty status is limited only to the quality of the product sold. There is no guarantee for the application other than the production of the product. This technical paper invalidates the previous existing form. The quality of the work done may vary depending on your professional use of the product. If you are unsure, do a little test or get technical help.
|
| Disposal |
Empty packaging can be disposed of in collection boxes according to local-local regulations or recycling rules. After drying and hardening the used waste material, dispose of it as construction waste. It is dangerous to destroy product residues by burning.
|
| Safety Information |
Keep the products out of the reach of children. Keep the covers of the products closed. It is recommended to wear gloves and goggles during work. If the skin comes into contact with the material, it should be washed with soapy water immediately. In case of contact with eyes, seek medical advice immediately. For more detailed information, see the material safety data sheet.
|
